Guide to Installing Poly Deer Fence

When it comes to protecting your garden or property from deer, a poly deer fence offers a reliable and cost-effective solution. Installing it may seem like a daunting task, but with the right guidance, it becomes a manageable project. In this comprehensive guide, we’ll walk you through the step-by-step process of installing a diy deer fence to ensure your space remains a sanctuary untouched by wandering wildlife.

Materials Needed:

  1. Poly Deer Fence Rolls: Ensure you have enough rolls to cover the entire perimeter of your space.
  2. Fence Posts: Sturdy posts to provide support and structure to the fence.
  3. Zip Ties or Twine: For securing the poly deer fence to the posts.
  4. Ground Staples or U-shaped Nails: To secure the bottom edge of the fence to the ground.
  5. Gate Kit (Optional): If you plan to create an entry point, a gate kit will be necessary.

Steps to Install Poly Deer Fence:

Step 1: Planning and Layout

  • Survey the area you want to enclose and mark the intended fence line.
  • Determine the number of rolls and posts needed based on the dimensions of your space.

Step 2: Install Corner and Gate Posts

  • Dig post holes at the corners of your fence line and at the intended gate location.
  • Insert corner and gate posts into the holes, ensuring they are level.
  • Backfill the holes with soil and tamp it down firmly.

Step 3: Set Intermediate Posts

  • Space intermediate posts evenly along the fence line, typically 8 to 10 feet apart.
  • Dig holes for each intermediate post and install them using the same method as corner posts.

Step 4: Run Tension Wire (Optional)

  • For added support, consider running a tension wire along the top of the posts.
  • Thread the wire through eyelets or clips on each post, and tighten it using pliers.

Step 5: Unroll Poly Deer Fence

  • Unroll the poly deer fence along the fence line, starting from one corner.
  • Ensure the fence reaches the ground, covering the entire intended area.

Step 6: Attach Fence to Posts

  • Use zip ties or twine to secure the poly deer fence to each post.
  • Ensure the fence is taut and properly attached to provide effective protection.

Step 7: Secure Bottom of the Fence

  • Secure the bottom of the fence to the ground using ground staples or U-shaped nails.
  • Bury the bottom edge a few inches below the surface to prevent deer from digging underneath.

Step 8: Install Gate (Optional)

  • If installing a gate, follow the manufacturer’s instructions for the gate kit.
  • Attach the gate to the gate posts using hinges, and install a latch for closure.

Step 9: Inspect and Adjust

  • Walk the entire length of the fence, inspecting for any gaps, loose sections, or potential weak points.
  • Adjust as needed, tightening zip ties or twine, and reinforcing any areas that may require extra support.